How to use a linear cutting stapler

Disposable linear cutter (suturing) stapler and staple cartridge component

Linear Cutting Staplers Includes staple cartridge component, staple butting seat, free handle and firing knob.

Open the pack, take out the cutter stapler, check whether the firing knob is at the initial position, release the handle, separate the instrument and take out the staple cartridge component protective cap. To demonstrate, put two pieces of foaming paper, fold the instrument, take care of that the firing knob position must be at the initial position, align the instrument opening groove with the locating pin in the instrument central axis direction on the other half of instrument to fold the instrument, then compress the handle, use a thumb and an index finger to pinch the firing knob, push it till the end in the instrument body central axis direction without stop in the process, retain the firing knob for 20-30 seconds after the end, then pull it back to the initial location, release the handle, separate the upper and lower instrument bodies and take out the instrument, check the suturing position, and if any errhysis, suture several stitches again. If secondary suture is required, take out the used staple cartridge component, use a left hand to hold the instrument body, and right hand index finger and thumb to pinch the convex part at the rear part of the staple cartridge component, and then pull it upwards to finish the suture. When an old staple cartridge component is replaced, firstly sleeve the front part of the staple cartridge component in the head part of the cutter stapler body, press the staple cartridge component down to the end, take out the staple cartridge component protective cap, before folding the instrument, check whether the firing knob is at the initial position, and perform the following operation same to the aforementioned.